Configuration Guide

57
Configure BWP
7.10
NOTE: In this software version, BWP does not be supported.
Configure SCS
7.11
1. In the left navigation column, select “NR Setting > SCS” to enter the Sub-carrier
Space (SCS) configuration page, as shown in Figure 7-8.
Figure 7-8 SCS Setting
2. In the DL SCS list, click to display the downlink SCS parameters, which
description is shown in Table 7-23.
Table 7-23 DL SCS Parameter Description
Parameter Description
SubcarrierSpacing The sub carrier spacing is 30kHz.
CarrierBandwidth
The bandwidth of the carrier.
Values are 25, 52, 79, 106, 133, 160, 216, 273.
The configuration of UL SCS is the same as DL SCS configuration.
3. Click “Save” to complete the uplink/downlink SCS setting.