Configuration Guide

53
Parameter Description
PAT2 of Downlink
Symbols
Subframe ratio. The special time slot downlink symbol
configuration of PAT2. Range is from 0 to 13.
PAT2 of Uplink
Slots
Subframe ratio. The uplink time slot configuration of PAT1.
Range is from 0 to 320.
PAT2 of Uplink
Symbols
Subframe ratio. The special time slot uplink symbol
configuration of PAT1. Range is from 0 to 13.
Max DL HARQ
ReTX
The maximum number of downlink HARQ retransmission.
Range is from 0 to 4.
DL LA
Downlink AMC auto adaptive switch.
 ON: Enabled
 OFF: Disabled
Max UL HARQ
ReTX
The maximum number of uplink HARQ retransmission. Range
is from 0 to 4.
UL LA
Uplink AMC auto adaptive switch.
 ON: Enabled
 OFF: Disabled
CsiRsReporting
CSI report switch.
 ON: Enabled
 OFF: Disabled
DU F1AP Local IP The DU IP address in control plane of F1 interface.
DU F1U IP The DU IP address in user plane of F1 interface.
DU F1AP Remote
IP
The Remote IP address in control plane of F1 interface.
numForceGrant (Reserved)
HealthTimeInterval (Reserved)
PerfOptFlag (Reserved)
CalcPaddingRateFl
ag
Calculate Padding rate flag.
2. Click “Save” to complete the DU setting.
7.8.3 SSB
1. Click + in the front of “SSB” to display SSB configuration parameters, as shown
in Table 7-18.
Table 7-18 PCI Range Parameter Description
Parameter Description
SSB Mask SSB mask. It is used to configure the number of SSB.
SSB Periodicity The period of SSB. The unit is ms. Range is from 0 to 5.
SSB Power The transmission power of SSB. Range is from -60 to