Configuration Guide

7.7.8 Period Measurement Parameter

1. In the Period Measure list, click to display period measurement configuration

parameters, which are shown in Table 7-15.

Table 7-15 Period Measurement Parameter Description

Parameter Description

Report Quantity The RS measurement report of the V1 event, including RSRP,

RSRQ, and SINR.

Max Report Cells The maximum cells of reported. Range is from 0 to 8.

Report Interval The report interval of A1 event triggering report.

Report Amount The report interval of A1 event triggering report. Range is

from 0 to 64 (even number).

2. Click “Save” to complete the period measurement setting

Configure Advanced Parameter

7.8

On the left navigation column, select “NR Setting > Advanced” to enter the advanced

parameter configuration page.

7.8.1 CU

1. Click + in the front of “CU” to display CU configuration parameters, as shown in

Table 7-16.

Table 7-16 CU Parameter Description

Parameter Description

NR T300

RRC timer. When the gNB receives the RRCSetupRequest

message, the timer starts up.

NR T301

RRC timer. When the gNB receives the

RRCReestabilshmentRequest message, the timer starts up.

NR T304

RRC timer. When the gNB receives the RRC reconfiguration

message with synchronization, the timer starts up.

NR T310

RRC timer. When the gNB receives the continuous

“out-of-

sync” message from the bottom layer, the timer starts

up.

NR T311

RRC timer. When the RRC reestablishment is triggered, the

timer starts up.

NR N310

This parameter is used to indicate that the Pcell receives the

maximum continuous “out-of-

sync” message from the bottom

layer.