Configuration Guide

48
Parameter Description
2: Inter-RAT EUTRA measurement.
The customized measurement event is from 10.
Report Amount The number of report. Range is from 1 to 100.
MaxNrofRSIndexToRe
port
The maximum number of RS measurement report. Range
is from 1 to 32.
Report Interval The report interval of A1 event triggering report.
Report Quantity The quantity of the measurement report.
Report Quantity RS
IDX
The RS measurement report of the A1 event, including
RSRP, RSRQ, and SINR.
Time To Trigger Trigger time.
RS Type RS type, including ssb and csi-rs.
Include Beam
Measurements
Enable or disable the beam measurement indicator.
 ON: Enable
 OFF: Disable
PLMN PLMN ID
2. Click “Save” to complete the A1 event threshold setting.
7.7.2 A2 Event Threshold
The A2 event is triggered when the serving cell’s Reference Signal Received Power
(RSRP) is better than the A2 threshold.
1. In the A2 list, click to display A2 event configuration parameters.
2. Input the value of A2 event, which is the same as A1 event, refer to Table 7-13.
3. Click “Save” to complete the A2 event threshold setting.
7.7.3 A3 Event Threshold
The A3 event is triggered when the neighbor cell becomes better than the serving cell
by as much as the offset value. The offset can be either positive or negative.
1. In the A3 list, click to display A3 event configuration parameters.
2. Input the value of A3 event, which is the same as A1 event, refer to Table 7-13.
3. Click “Save” to complete the A3 event threshold setting.