Configuration Guide

37
Figure 7-2 NR Neighbor Frequency/Cell Settings
Users can add, modify, and delete the NR neighbor frequency and cell.
Intra Frequency Measurement
2. In the IntraFREQ Measurement list, click to enter the page for adding an
intra frequency measurement, the parameter descriptions are given in Table 7-3.
Table 7-3 Intra Frequency Measurement Parameter Description
Parameter Description
SSBlocksConsolidation
Rsrp
The consolidation of Synchronization Signal and PBCH
block (SSB) blocks of
Reference Signal Receiving Power
(RSRP). Range is from 0 to 127.
SSBlocksConsolidation
Rsrq
The consolidation of SSB blocks of Reference Signal
Receiving Quality (RSRQ). Range is from 0 to 127.
SSBlocksConsolidationS
inr
The consolidation of SSB blocks of
Signal to Interference
plus Noise Ratio (SINR). Range is from 0 to 127.
NrofSSBlocksToAverage
This parameter indicates the signal qu
ality of a cell in NR
measurement of SSB. Range is from 2 to 16.
RsrpOffsetSSB The SSB offset of RSRP. Range is from 0 to 30.
RsrqOffsetSSB The SSB offset of RSRQ. Range is from 0 to 30.
SinrOffsetSSB The SSB offset of SINR. Range is from 0 to 30.
RsrpOffsetCsiRs The CSI-RS offset of RSRP. Range is from 0 to 30.
RsrqOffsetCsiRs The CSI-RS offset of RSRQ. Range is from 0 to 30.
SinrOffsetCsiRs The CSI-RS offset of SINR. Range is from 0 to 30.
BitmapType Bitmap type. Range is 0, 1, 2.
Bitmap Bitmap. Range is from 0 to 18446744073709551615.
DeriveSSBIndexFromCe
ll
Whether the frame boundaries of all cells at this
frequency point are the same. Range is 0 or 1.