Configuration Guide

35
Parameter Description
neighboring gNBs, as determined by the received signal level at
the UE. If the received signal level is better from a neighboring
gNB by at least this amount of difference in dB, the UE will
reselect the other cell.
The range is -24 to +24. A typical value is 0dB.
WideBandRsrqM
eas
The RSRQ measurement of the bandwidth. Range is 0 or 1.
CellReselection
Priority
Priority of the cell reselection to cells at this frequency. Range is
0 to 7 (integer). A typical value is 4.
ThreshXHigh The cell reselection threshold for higher priority inter-band
frequency.
Represents the access threshold level, at which the UE will leave
the serving cell and reselect another cell at the target frequency
(assuming the target frequency cell has a higher reselection
priority t
han the serving cell). Range is 0 to 31dB. A typical value
is 18 dB.
ThreshXLow The cell reselection threshold for lower priority inter-band
frequency.
Represents the access threshold level at which the UE will leave
the serving cell and reselect another cell at the target frequency
(assuming the target frequency cell has an absolute priority
lower than the serving cell). Range is 0 to 31dB. A typical value
is 13 dB.
QRxLevMin
The minimum received signal level at which user equipment (UE)
will detect a ne
ighboring gNB’s signal. Range is from -70 to -22.
QQualMin The minimum received signal quality. Range is from -34 to -3.
PMaxEUTRA
The maximum transmit power that UEs in this cell are allowed to
use in the uplink. Range is -30 to 33 dBm. A typical value is 23
dBm.
PLMNID PLMN ID
LTE Neighbor Cell
4. In the neighbor cell list, click to enter the page for adding a LTE neighbor cell,
the parameter descriptions are given in Table 7-2.
Table 7-2 LTE Neighbor Cell Parameter Description
Parameter Description
PLMNID PLMN ID
CID Unique identification number for the Cell.
EUTRACarrierARFC Frequency point of the neighbor cell.