Configuration Guide

25
Parameter Description
 Clear
 Hold
 Restart
Dpddelay Time interval for sending the DPD detection message.
Format: Seconds, Minutes, Hours or Days.
Left Interface The interface on the eNB side.
5. Input strong wan configuration parameters, as shown in Table 5-7.
Table 5-7 Strong Wan Parameter Description
Parameter Description
IKE Debug Level
IKE debug level. Range: -1,0,1,2,3,4。
ESP Debug
Level
ESP debug level. Range: -1,0,1,2,3,4。
CFG Debug
Level
CFG debug level. Range: -1,0,1,2,3,4。
KNL Debug Level
KNL debug level. Range: -1,0,1,2,3,4。
MGR Debug
Level
MGR debug level. Range: -1,0,1,2,3,4。
ASN Debug
Level
ASN debug level. Range: -1,0,1,2,3,4。
CHD Debug
Level
CHD debug level. Range: -1,0,1,2,3,4。
LIB Debug Level
LIB debug level. Range: -1,0,1,2,3,4。
Port Port number.
Port NAT T NAT T port number.
Retry Initiate
Interval
Retry initiate interval.
MTU Maximum transmission unit. The maximum value is 9600 bytes.
MCS MCS. Range: 0 ~ 9600 bytes
6. Click “Save” to complete the IPsec configuration.
Configure DSCP
5.3
1. In the navigation column on the left, select “Network > DSCP” to enter the DSCP
configuration page, as shown in Figure 5-9.