Configuration Guide

22
2. Select enable or disable the IPsec function.
The IPsec function is enabled by default.
3. If the IPsec function is enabled, click to add a IPsec tunnel.
4. In “IPsec Tunnel List” area, click to enter the edit dialog box, as shown in
Figure 5-8.
Figure 5-8 Edit IPsec Tunnel
The description of basic parameters is shown in Table 5-5.
Table 5-5 IPsec Tunnel Basic Parameter Description
Parameter Description
Enabled Enable or disable this IPsec tunnel.
LeftAuth
Attention: DO NOT recommend to change the value!
Local authentication type of the IPsec. Must be consistent
with the security gateway side
.
 PSK
 PUBKEY
RightAuth
Attention: DO NOT recommend to change the value!
Peer authentication type of the IPsec. Must be consistent
with the security gateway side
.
 PSK
 PUBKEY
Gateway The security gateway (IPsec server) IP address. Make sure
the IP address entered here matches the actual IP address