Configuration Guide

18
Figure 5-3 Configure WAN Interface Attribute
5. Configure IPv4, IPv6, or VLAN parameters based on the actual network
deployment.
 IPv4
Click on “WAN IPv4 table” zone to display the IPv4 configuration
parameters, as shown in Figure 5-4
Figure 5-4 IPv4 Configuration Parameters
The description of IPv4 configuration parameters is shown in Table 5-2.
Table 5-2 IPv4 Parameter Description
Parameter Description
Addressing
Type
The interface protocol used by WAN interface, include:
 DHCP: If DHCP is selected, no other parameter needs
to be configured.
 Static: If Static is selected
, the IP address, gateway and
subnet mask should be configured.
Port Type WAN port type. According to the network plan, specify the