Configuration Guide

9
4. Configure System Parameter
Configure NTP
4.1
This page includes the time zone and the NTP configuration, which are configured
according to the actual needs. If the NTP is used by the gNB as an external clock
source, up to five NTP servers are supported, where one for master NTP service and
the others for backup.
1. In the navigation column on the left, select “System > NTP” to enter the NTP
setting page, as shown in Figure 4-1.
Figure 4-1 NTP Server Setting
The page displays the current date and time.
2. Select the Time Zone of the eNB locating.
3. Select whether enable the NTP function.
4. Input NTP server parameters, the parameter description is shown in Table 4-1.
Table 4-1 NTP Server Parameter Description
Parameter Description
NTPServer1 Domain name or IP address of the master
NTP server. Must
be consistent with the other end.
NTPServer2 Domain name or IP address of the slave NTP server. Must
be consistent with the other end.
NTPServer3 Domain name or IP address of the slave NTP server. Must
be consistent with the other end.
NTPServer4 Domain name or IP address of the slave NTP server. Must
be consistent with the other end.
NTPServer5 Domain name or IP address of the slave NTP server. Must
be consistent with the other end.