Configuration Guide

4
Figure 2-1 Internet Protocol Version (TCP/IPV4)
Select either “Obtain an IP address automatically” or “Use the following IP
address”:
 If “Obtain an IP address automatically” selected, go directly to step 7
 If “Use the following IP address” selected, follow step 5 ~ step 7
NOTE: In general, if the auto obtaining fails, one needs to set up the IP address manually.
5. Select “Use the following IP address”.
6. Input IP address of the Operation and Maintenance (OAM) interface, subnet
mask, and default gateway, and then click “OK”.
 IP address: 192.168.150. XXX: (recommended XXX: 100~254)
Because the LAN interface of the base station uses the IP address of
192.168.150.1, others should avoid using this address.
 Subnet mask: 255.255.255.0
 Default gateway: 192.168.150.1
NOTE: The default OAM IP address is 192.168.150.1/24. If the eNB configures IP address in
other segments, you should configure according to the actual networking.