User's Guide
BAGEL LABS_BAGEL-003_USER GUIDE_v1.0
4. Regulatory Information
You can check the device’s regulatory information on its e-label, which can be accessed by
following these steps below.
Step 1. Connect a power source to the device using the charging port and a USB cable.
Step 2. Press and hold Button 2 and Button 3 simultaneously, for 2 seconds.
Step 3. Toggle through e-label pages by pressing Button 1.
4.1. FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Caution
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
FCC Interference Statement
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
device generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference to radio or
television reception, which can be determined by turning the device off and on, the user
is encouraged to correct the interference by one of the following measures:
❏ Reorient or relocate the device.
❏ Increase the separation between the device and the receiver.
❏ Connect the device into an outlet on a circuit different from which the receiver is
connected.
❏ Consult the manufacturer for help.
7