Installation Guide

First InterComm ™ System VCA100 Installation Guide
A29799 rev A Page 27
PROPRIETARY INFORMATION: This document contains trade secrets and commercial or financial information that is the property of BAE
Systems Electronics and Integrated Solutions (E&IS). Further dissemination or disclosure of this information is strictly prohibited without
the written permission of BAE Systems.
Figure B-2.2 Serial IP Program Configuration Wizard
B.3 Kenwood Radio Programming Software
Kenwood Radio Programming software is used as a utility program to configure the
VCA100 Radio Module.
NOTE
IT IS REQUIRED TO PROGRAM ALL RADIOS PER THE PARAMETERS IN TABLE B-2
BELOW.
The procedure is to:
1. Start the VCA Manager Program and Serial IP program (Paragraph B.1 & B.2
above) to link the COM2 port to the VCA100 being programmed.
2. Consult Table B-1 below to find the First InterComm™ System VCA100 Model and
then launch the corresponding Kenwood Radio programming software for the
VCA100 being programmed.
3. Set COM port used in the Kenwood software to COM2.
4. Consult Table B-2 below, Required Kenwood Radio Parameters To Be
Programmed, and program the values appropriate to the model being updated.
5. Consult Table 7, Required User Information, and program the appropriate values
into the VCA100 radio module.