Replacement Part List

CLEANING
STORAGE
•
Never store a fueled unit where fumes may reach an open flame
or spark.
Allow the engine to cool before storing.
Lock up the unit to prevent unauthorized use or damage.
Store the unit in a dry, well-ventilated area.
Store the unit out of the reach of children.
To suspend the attachment from a hook, install the hanger cap
onto the attachment. Make sure the release button is securely
locked into one of the holes on the hanger cap.
•
•
•
•
•
Use a small brush to clean the outside of the unit. Do not use strong
detergents. Household cleaners that contain aromatic oils such as
pine and lemon, and solvents such as kerosene, can damage
plastic. Wipe off any moisture with a soft cloth.
Short-term Storage (1-2 weeks)
1. Store the unit in a horizontal position. If this is not possible, store
the unit vertically with the engine at the top.
Long-term Storage
1.
Remove the fuel cap, tip the unit and drain the fuel into an
approved container. Reinstall the fuel cap.
Start the engine and allow it to run until it stalls. This ensures
that all fuel has been drained from the carburetor.
Allow the engine to cool. Remove the spark plug and put 5
drops of any high-quality motor oil or 2-cycle oil into the
cylinder. Pull the starter rope slowly to distribute the oil. Reinstall
the spark plug.
Thoroughly clean the unit and inspect it for any loose or
damaged parts. Repair or replace damaged parts and tighten
loose screws, nuts or bolts.
2.
3.
4.
Preparing the Unit for Use after Long-term Storage
1. Remove the spark plug.
Tip the unit and drain all of the oil from
the cylinder into an approved container. Reinstall the spark plug.
NOTE: Do not use fuel that has been stored for more than 30 days.
Dispose of old fuel and oil according to federal, state and local
regulations.
WARNING: To avoid serious personal injury, always
stop the engine and allow it to cool before cleaning or
maintaining the unit.
CLEANING AND STORAGE
24
The angle must also be maintained for all knives.
For irregular angles, the chain is run irregularly, wear quickly and break down prematurely.
Since these requirements can only be met with sufficient and regular exercise:
- A File Holder must be used when sharpening the saw chain by hand. The correct filing angle
marked on it.
- Hold the file horizontally (at a right angle to the guide rail) and file according to the angle mark on
the file holder. Support the file holder on the top plate and depth gauge.
- File down. The knife is always from the inside to the outside
- The file sharpens only in forward motion. Lift it off in the backward motion.
- Do not touch the dynamic links with the file.
- Turn the file regularly continue to avoid a onesided wear.
- Remove to remove a piece of hard wood, bones raw edges.
All knives must have the same length, otherwise they will also vary. As a result, the chain is irregular
and it increases the risk of going broke.
Lubricate angle transmission
Lubricate with lithium-based grease. Remove the screw and put in the grease, turning the shaft
manually until grease emerges, then replace the screw.