Use and Care Manual

Putting the machine in operation (Fig. 5 and 6)
■ Insert the charged battery in the strimmer until the interlock (15) latches. The rechargeable battery
can only be inserted in the strimmer in one position (Fig.5).
Directions for set lenght adjustment and the use of the set as edge cutter (Fig. 7, 8, 9, 10)
The tube length may be adjusted to suit your height (Fig. 7):
■ To do so, turn the ribbed plastic sleeve clockwise to loosen the connection. Adjust the tube to the suitable
length and fasten the connection by turning the tapped sleeve anti-clockwise.
Adjusting the tilting angle (Fig. 8):
■ Press the button (8) - the strimmer head is disengaged and can be pivoted in 72° relative to the shaft.
Adjusting for edge trimming (Fig. 7, 8 , 9, 10):
■ Set the tilting angle as previously described.
■ Press the edge cutter adjustor (11) and rotory the handle with clockwise with 180°, then the edge
cutter spool would directs to ground. It’s for edge trimming.
Instructions for operating the mowing machine (Fig.11)
Move the mowing machine evenly from oneside to another.
■ If possible, mow by using the left half of the mowing machine.
The mowed parts of plants and / or stones will thus be hurled forward away from the operating person.
■ The best possible cutting result are achieved when you hold the trimmer with an angle of 20°- 30° to the
left side.
■ Avoid contact between the mowing string and obstacles such as fences, walls, stones, etc. This leads to
excessive wear and tear.
Changing the spool (Fig. 12)
10
OPERATION INSTRUCTIONS
Attention- risk of injury!
Always remove the rechargeable battery from the device before all work.
Press the nylon spool head cap claw (2) and pick out the worn spool (3), replace a new spool to the spool
frame (4)with the line out of the hole of the spool frame, and replace the cap (1) to the nylon head.
Attention: The nylon head is with single line, not double.
Attention
When inserting the battery do not actuate the switch-on inhibit (2) and the on/off switch (1).
Attention
On/off switch can only be activated after the switch-on inhibit (2) is pressed.
■ Adopt a safe stance. Hold the strimmer in both hands.Do not set the cutting device down on the
ground. Press the switch-on inhibit (2) to right and actuate the switch (1) (Fig. 6). After switching
on, the switch-on inhibit (2)must no longer be held.
■ In order to switch off, release the switch (1) (Fig. 6).