Instruction Manual

Brush Cutter Blade Install
Items needed
1. Remove String Trimmer Spool
2. Remove clamp washer / spacer
3. Install brush cutter blade (note: the blade is made to spin in either direction)
4. Put on clamp washer
5. Put on nut protector washer
6. Put on nut (note: this is reverse threaded)
7. Put allen wrench in arbor lock hole
8. Tighten lock nut down as tight as you can make it. (note: the blade fits onto
the thrust washer by setting onto the raised 1” arbor space, you will need to
ensure it is aligned or it will not seat correctly.
9. It should look like picture 12 when assembled.
Pic 12