Instruction Manual

Tools: Allen wrenches included with kit
It is crucial that the attachment tubes are seated all they way into the attachment housings for the drive shafts to register properly.
Drive shaft square end should be flush with connection tube end.
1. Back the tension and set screws all the way out but do not remove from the housing
2. Insert tube with set screw hole aligned with set screw
3. Spin the set screw in by hand until you feel it contact the tube then rotate the tube as needed to align the hole. Once you have the
alignment cinch down the screw being careful to not overtighten. A quarter turn past bottom will do.
4. Tighten tension screw to a good snug fit.
Final assembly should look like fig 2 and 3
Edger Attachment
FIG 3
Set Screw
hole
Drive end
inserted into
edger
housing
Tighten Set Screw
Tighten Tension Screw
Remove depth knob
This makes room to
tighten the set
screws
Put depth
knob back on
the tool
Connection end
Note the detent pin