Instruction Manual

Tension
Screws
Set Screw
Pole Saw Attachment
It is crucial that the attachment tubes are seated all they way into the attachment housings for the
drive shafts to register properly.
1. Back the tension and set screws all the way out but do not remove from the housing
2. Insert tube with set screw hole aligned with set screw
• (you may need to use the mallet to gently tap the tube all the way in)
3. Spin the set screw in by hand until you feel it contact the tube then rotate the tube as needed to
align the hole. Once you have the alignment cinch down the screw being careful to not
overtighten. A quarter turn past bottom will do.
4. Tighten tension screws to a good snug fit.
Final assembly should look like fig 1 and 2
FIG 1 FIG 2
Same Process As Hedge Trimmer