Attachment Assembly Addendum
Hedge Trimmer Attachment Tools: Rubber mallet Allen wrenches included with kit FIG 2 FIG 1 Set Screw hole Tension Screw Set Screw It is crucial that the attachment tubes are seated all they way into the attachment housings for the drive shafts to register properly. 1. Back the tension and set screws all the way out but do not remove from the housing 2. Insert tube with set screw hole aligned with set screw • (you may need to use the mallet to gently tap the tube all the way in) 3.
Pole Saw Attachment FIG 1 FIG 2 Tension Screws Same Process As Hedge Trimmer Set Screw It is crucial that the attachment tubes are seated all they way into the attachment housings for the drive shafts to register properly. 1. Back the tension and set screws all the way out but do not remove from the housing 2. Insert tube with set screw hole aligned with set screw • (you may need to use the mallet to gently tap the tube all the way in) 3.
String Trimmer Attachment This unit is preassembled with the exception of the shield and should be seated correctly. One issue that we commonly see is users inadvertently removing the Spacer Washer on the string trimmer head. This creates a situation where the Tap –N- Go Spool head gets pinched on to the shroud and cannot spin freely. The washer is shown in Fig 1; proper install is shown in Figures 2 through 4.
Edger Attachment Tools: Allen wrenches included with kit Connection end Note the detent pin Set Screw hole Drive end inserted into edger housing Tighten Set Screw FIG 3 Remove depth knob This makes room to tighten the set screws Put depth knob back on the tool Tighten Tension Screw It is crucial that the attachment tubes are seated all they way into the attachment housings for the drive shafts to register properly. Drive shaft square end should be flush with connection tube end. 1.
Brush Cutter Blade Install Items needed 1. 2. 3. 4. 5. 6. 7. 8. 9. Remove String Trimmer Spool Remove clamp washer / spacer Install brush cutter blade (note: the blade is made to spin in either direction) Put on clamp washer Put on nut protector washer Put on nut (note: this is reverse threaded) Put allen wrench in arbor lock hole Tighten lock nut down as tight as you can make it.
Edger Attachment Tools: Allen wrenches included with kit Set Screw Connection end of shaft FIG 2 Twist drive cable to align and push in to drive socket Drive cable square end should be flush with tube end Set Screw Set Screw hole Drive end inserted into edger housing Tension Screw Insert assembly into housing and align set hole to set screw and hand tighten Tension Screw Tighten Set Screw FIG 3 Remove depth knob This makes room to tighten the set screws Put depth knob back on the tool Tighten
Items needed Housing Bottom Housing Top Mount fan onto arbor with the top (hex pocket) up. Align with hex on arbor. Fan will be flush to top of housing by spin freely. Blower Attachment Assembly Fan – Top View Should look like this Curve Shaft With Lower Connection Fasten with three screws provided Insert Shaft into housing top Put on Washer, lock Should look like this washer and nut. Use pliers or wrench to tighten nut. Just hold the fan to snug up the nut.
