User guide
Table Of Contents
- Introduction
- Overview of ReadCenter Analytics and Analytics Mobile
- Program Startup
- Main Screen
- System Outline
- Fixed and Mobile Reading Cycles
- Save/Clear Reads
- Read Input File
- Apply Gateway Readings to the Customer Account Records
- Load Collectors
- Unload Collectors
- Route Reading Reports / Run Reports
- Write Output File
- Gateway Reading Reports
- Custom Reports
- Analytics
- Accounts and System Settings
- System Requirements
- Software Function Detailed Description
- Codes
- Using the Tool Bars
- Radix Handheld File Transfer
- ReadAll Handheld File Transfer
- Mini Mobile Interrogator (MMI) File Transfer
- Backup Operation
- Troubleshooting
- Technical Support

MINI MOBILE INTERROGATOR MMI FILE TRANSFER
Mobile Only: This section is intended for customers with a mobile network. Customers using ReadCenter Analytics exclusively
for a fixed network may skip this section.
When the MMI box is selected, ReadCenter Analytics or Analytics Mobile activates the MMI File Transfer process to
communicate to and from the MMI storage device, either diskette or USB memory.
Load Collectors – MMI
ReadCenter Analytics
Route Reading> Load Collectors
ReadCenter Analytics Mobile
Meter Reading Cycle> Load Collectors
If the configuration option to support MMI file transfer is set and TRACE is selected on the master tab, the MMI check box will
be shown on the screen for Load Collectors and Unload Collectors when the Laptop Reader device is chosen.
Before starting with Step 1, go to System Configuration> General in the main tool bar and make sure the Radix/MMI/
ReadAll File Transfer configuration option is selected. Then choose the Master tab and select TRACE.
Step 1 Select accounts to be loaded.
Step 2 Click View Selected Accounts to verify the chosen accounts.
Step 3 Select the Laptop Reader device, check the MMI box, and enter the File Location where the information will be
sent. You may also click Browse to look for the File Location.
OTE:N Do not check "With Work Items."
Step 4 Click Load Collector to send the file to the designated location.
User Manual
Page 105 June 2014