Specifications

ORION® Remote Endpoint for Gas Meters and Volume Correctors with Pulsed Outputs
MOUNTING AN ORION REMOTE ENDPOINT TO A PIPE
Insert the clamp through the appropriate slots on the rear of the ORION endpoint.
It may be necessary to remove the endpoint from the housing to accomplish this. See pages 9-10.
The clamp ts on a pipe up to 3 inches in diameter.
A stainless steel clamp is recommended if a larger clamp is needed.
MOUNTING AN ORION REMOTE ENDPOINT TO A FLAT SURFACE
To mount a endpoint to a at surface, such as a wall or post, four (4) screws (size #8 x 1") are provided.
Mounting holes are provided at each corner of a remote endpoint.
1. Place a screw in each hole.
2. In one lower corner of the remote endpoint place a screw and the strain relief.
3. Screw the endpoint into a wall or post.
Page 12
(4-11)