Installation Manual
Integral Endpoint Installation
ORI-UM-00025-EN-24
HR-E Encoder Integral Conguration
Figure 48: HR-E Integral assembly with additional wire
6.7 in
170 mm
4.21 in.
107 mm
Figure 49: HR-E Integral base dimensions
Configuration
The ORION HR-E Integral Assembly is shown in Figure 48. The endpoint has a 3-foot length of wire stored inside the bottom of
the assembly housing. The endpoint can be removed from the housing, if necessary, and mounted away from the encoder.
OTE:N Once removed, the endpoint CANNOT be reassembled into an integral configuration.
Removing the Endpoint from the Assembly Housing
MPORTANTI
Removing the endpoint from the assembly housing can only be done once with this integral configuration.
PRIOR TO DISASSEMBLING AN INTEGRAL ENDPOINT, VERIFY THAT THE ENDPOINT HAS THREE FEET OF WIRE
PACKAGED WITH THE ASSEMBLY. CHECK THE SERIAL NUMBER LABEL ON THE SIDE OF THE INTEGRAL BRACKET
TO MAKE SURE IT INDICATES “3 FT WIRE.” DO NOT CONTINUE WITH THE STEPS LISTED BELOW IF YOUR INTEGRAL
ENDPOINT DOES NOT HAVE THIS DESCRIPTION ON THE SERIAL NUMBER LABEL, AS ENDPOINT DAMAGE WILL OCCUR.
1. Remove the assembly from the meter.
• Remove the security screw at the base of
the assembly. Keep the screw for remounting the
encoder assembly.
• Turn the assembly (as one piece) 1/4 turn,
counter-clockwise.
• Lift the assembly off the meter.
Figure 50: Remove assembly from meter
Page 26 November 2020