Installation Manual

69406-001 Mounting Bracket Install Kit for ORION Endpoint and E-Series Ultrasonic Meter
ORI-UM-00025-EN-24
2.35 in.
60 mm
1.36 in.
35 mm
69406001 MOUNTING BRACKET INSTALL KIT FOR ORION ENDPOINT AND
ESERIES ULTRASONIC METER
Mounting Bracket Install Kit (69406-001) is designed to securely install an ORION endpoint to an E-Series Ultrasonic meter
for non-submerged indoor and outdoor remote applications. The bracket can be used for installations in any nonmetallic joist,
wall or pit application.
For use with: ORION SE, ME and CE endpoints
Figure 17: Mounting bracket with locking clip in place Figure 18: Mounting bracket and locking clip dimensions
To connect the bracket to the meter and endpoint, follow these steps.
OTE:N The kit components are the mounting bracket (68789-001) and the locking clip (68790-001). Keep the two pieces
separate when you start.
1. Feed the endpoint wiring cable through the mounting bracket
central opening.
You will see a small triangle on the underside of the bracket
(Figure 19) and at the bottom of the endpoint.
Align the triangles, push the bracket and endpoint together and
twist the endpoint clockwise until the endpoint clicks into place.
Figure 19: Triangle on underside of bracket
2. Align the tabs of the mounting bracket to the tabs on the side of
the E-Series register (Figure 20). Then slide the mounting bracket/
endpoint down into place on the register.
3. Once the endpoint is mounted on the E-Series register, insert
the locking clip underneath the mounting bracket in the space
between the mounting bracket and the register. The at side of
the locking clip should face the mounting bracket and t in the
mounting bracket grooves. It will click into place and lock.
Figure 20: E-Series Ultrasonic meter register tabs
OTE:N The endpoint is secure and cannot be
removed until you remove the locking clip.
4. Make sure the endpoint antenna is upright in its
nal position.
Figure 21: ORION endpoint mounted on E-Series meter register
1.88 in.
48 mm
1.94 in.
49 mm
Bracket
Locking clip
Page 17 November 2020