Hardware Solutions for Gas Utilities User Manual

ORION® Integral Endpoint for American® RPM Series Rotary Gas Meters
PLACE THE FRONT GASKET ON THE ENDPOINT
Place the gasket so that its two holes go over the two protruding tines.
Be sure the notched end goes around the guide pin on the side of the endpoint.
Be certain that the stepped edge is toward the endpoint boot and seated between the endpoint sealing face and the
alignment tabs.
INSTALL THE COVER
Place the cover over the endpoint and tighten it with the four (4) remaining screws.
Holes Over Tines
Notched End
Around Guide Pin
Endpoint
Sealing Face
Endpoint Boot
Stepped
Edge
Alignment
Tabs
Phillips
Screwdriver
Cover
Page 12
(4-11)