Hardware Solutions for Gas Utilities User Manual

Installation Data
2. Place a nut on each screw on the bottom of the adapter plate. Tighten the screws into the nuts with a Phillips
screwdriver.
3. Place the gas meter adapter plate, with endpoint assembly attached, on the meter with the
three (3) 1/4 x 20 3/8 screws.
Be sure the endpoint drive shaft mates with the meter drive pawl. Below is a cut-away view of the
endpoint showing the drive shaft and drive pawl.
4. Retighten the three (3) Allen screws on the meter adapter plate.
Meter
Drive Pawl
Endpoint Drive
Shaft
Phillips
Screwdriver
Bottom of
Adapter Plate
Nut on each Screw
(4-11)
Page 11