Hardware Solutions for Gas Utilities Owner manual

Installation Manual
Figure 21: Tighten endpoint screws
Move the TWO-FEET or ONE-FOOT dial back and forth to verify pawl connections. See Figure 22.
Figure 22: Verify pawl connections
Place the Cover Over the Endpoint and Index
1. Verify the front gasket is set properly.
Figure 23: Verify gasket is set properly
2. Place the cover on the gas meter and tighten it with the four (4) remaining screws (15 inch-pounds max).
Figure 24: Cover placement on meter
The endpoint unit is now ready for programming.
Page 13 July 2014