Hardware Solutions for Gas Utilities Manual

Installation Manual
Adding Additional Labels
If the utility chooses to add an additional label, follow the steps below. If not, see "Install The Orion Integral Endpoint And
American Cover Plate" on page 16.
Serial number label
Figure 22: Serial number label
1. With a needle nose pliers, pull the plastic cover plate down and o. See Figure 23.
Figure 23: Remove plastic cover
2. Place a new serial number tag above the one that is on the endpoint.
Figure 24: Place new serial number tag
3. Place the cover plate back on the endpoint.
Figure 25: Place cover plate on endpoint
Page 15 July 2014