Hardware Solutions for Gas Utilities Manual

Installation Manual
5. Use four (4) 18-18 X 3-1/2 supplied mounting screws to attach the index, cover plate and ORION integral endpoint to
the gas meter. Place two screws, with a washer on each, into two corners of the cover mounting plate.
Washer
Figure 13: Placement of screws with washer
6. Place two of the screws, without washers, through the white seal caps. Place them in the other two corners of the
cover mounting plate.
Figure 14: Placement of screw with white seal cap
7. Tighten all screws evenly with a large screwdriver to approximately 70 inch-lbs.
Figure 15: Tighten screws
Page 11 July 2014