Hardware Solutions for Gas Utilities Instruction Manual

ORION® Gas Endpoints, Integral Endpoint for Itron®/Actaris® Residential Slope-Face Gas Meters
3. Place the lens gasket on the other side of the endpoint.
a. Place the gasket so that the small pin at the bottom of the endpoint fits through the gasket, and the four lens screw
posts fit through the gasket holes.
b. Be certain that the gasket edge fits around the guide pins.
Guide pins
Gasket
Small pin
Lens screw
post
Figure 10: Lens gasket placement
INDEX INSTALLATION ON ENDPOINT
There are two (2) index measurement styles: dials and odometer. And there are two (2) procedures to mount the index: one
procedure uses slots, the other uses holes.
Slots
Dials
Holes
Odometer
Figure 11: Index styles
Place Screws into Index
Place two (2) #8 X ½" self-tapping screws into the index a short way. See Figure 12.
Figure 12: Self-tapping screw placement
Page 10 July 2014