Hardware Solutions for Gas Utilities Instruction Manual

ORION® Integral Endpoint for Roots® B3 Series Rotary Gas Meters
PLACE THE FRONT GASKET ON THE ENDPOINT
Place the gasket so that its two holes go over the two locating tines. Be sure the notched end goes around the guide pin at
the side of the endpoint.
Be certain that the stepped edge is toward the endpoint boot and seated between the endpoint sealing face and the
alignment tabs. The weep holes in the gasket should be facing downward.
Install the Cover
Place the cover over the endpoint and tighten it with the four (4) remaining screws. Tighten the screws to about
6 inch-pounds.
Phillips Screwdriver
Cover
Endpoint Sealing Face
Endpoint Boot
Stepped Edge
Alignment Tabs
Two Holes Over Tines
Notched End
Around Guide Pin
Page 12
(4-11)