Hardware Solutions for Gas Utilities Instruction Manual

Installation Data
ATTACH ENDPOINT TO ADAPTER PLATE OF GAS METER
1. Place the endpoint over the gas meter adapter plate.
2. Adjust the endpoint drive shaft on the gas meter drive pawl.
3. Screw the endpoint down with four (4) 10 x 24 screws. Tighten the screws to about 6 inch-pounds.
Endpoint
Gas Meter
Adapter Plate
Gas Meter
Drive Pawl
Endpoint Drive
Shaft
Phillips Screwdriver
Four (4) Screws
Through Gasket
(4-11)
Page 11