Hardware Solutions for Gas Utilities Instruction Manual

ORION® Integral Endpoint for Roots® B3 Series Rotary Gas Meters
SPACER ON GAS METER
1. Place the spacer, included in kit, onto the gas meter drive shaft.
2. Place the drive pawl over the spacer and onto the drive shaft.
ATTACH REAR ENDPOINT GASKET
The gasket should be attached to the endpoint at the factory.
If the gasket is not attached, place the rear gasket on the rear of the endpoint.
Place the protruding two tines into the two small holes, located between the two large holes, on each side of the endpoint.
Plastic Drive
Pawl
Spacer on
Drive Shaft
Drive Pawl onto
Drive Shaft
Drive Pawl on
Drive Shaft
Tine
Tine
Rear Gasket
Page 10
(4-11)