Hardware Solutions for Gas Utilities

Installation Data
2. When mounting an ORION integral endpoint to a gas meter make sure the endpoint drive pawl
engages the gas meter drive pawl. These two drive pawls must mate without causing any binding or
potential for disengagement.
3. Test to ensure the pawls are engaged and moving freely.
4. Be sure the gas INLET markings are on the same side of the meter and the lens faces forward.
Placing endpoint
on meter incorrectly may
damage the output seal
of the gas meter.
Endpoint
Drive Pawl
Meter Drive
Pawl
Gas Inlet
Markings
Lens Facing
Forward
(4-11)
Page 11