Hardware Solutions for Gas Utilities

Installation Manual
INSTALL ORION GASKETS, ADAPTER, ENDPOINT, INDEX AND COVER
1. Begin installation by placing a new meter gasket on the adapter. Remove the protective paper, line-up the four holes and
stick the gasket on the at side of the adapter. See Figure 5.
Protective paper
Meter gasket on at
side of adapter
Figure 5: Remove protective paper from meter gasket
2. Place the adapter with the gasket onto the meter housing with four (4) ¼-20 x ½" supplied screws. See Figure 6. Torque the
screws to 15 inch-pounds maximum.
Figure 6: Place adapter with gasket onto meter housing
3. Place the housing gasket on the rear of the endpoint. Put the rubber posts through the endpoint holes. See Figure 7.
Figure 7: Placement of housing gasket on endpoint
Page 9 July 2014