Hardware Solutions for Gas Utilities

ORION® Gas Endpoints, Integral Endpoint for Itron®/Actaris® Straight-Face Gas Meters
OTE:N Use care when handling the ORION endpoint to ensure the drive shaft is not subjected to any physical abuse. Abuse
may cause this spindle to become bent, misaligned or otherwise inoperative.
8. Attach this assembly onto the meter with three (3) 8-16 x ½" screws. See Figure 14. Tighten screws to
15 inch-pounds maximum.
Figure 14: Attach assembly onto meter
9. Place the cover gasket on the endpoint. Put the hole in the cover gasket around the lower endpoint post. See Figure 15.
Cover gasket
Gasket hole and
locating post
Figure 15: Cover gasket placement
Page 12 July 2014