Hardware Solutions for Gas Utilities User Manual

Installing the ME Driver for Windows XP
OTE:N This driver only needs to be installed once. If you already have the ME driver installed, skip this section.
1. From the software disc, copy the "OrionSE_USB_0_2.inf” le.
2. Click the Windows Start button. Then click My
Computer and paste the OrionSE_USB_0_2.inf le
on the C:\ drive of the laptop.
Result: The le appears in the C:\ drive as shown.
3. Connect the ME/SE transceiver to a power supply
and to a USB port on the laptop.
When it is connected to the laptop, turn the ME/SE
transceiver power on.
Result: A small window opens at the bottom of the
computer screen alerting you to new hardware.
OrionSE_USB_0_2.inf on the C:\ Drive
OTE:N If the new hardware alert does not display automatically, disconnect the ORION ME/SE transceiver and
reconnect it. Make sure the transceiver is connected to a power supply and is switched on after you connect
it to the USB port. The power light should be on, indicating the transceiver is on.
4. The New Hardware Wizard should open
automatically. If it does not, click the small new
hardware alert window described in Step 3.
5. Select the radio button next to "No, not this time"
and click Next.
New Hardware Wizard
INSTALLING THE SOFTWARE
Page 41 April 2014 ORION® SE/ME Firmware Updater