Hardware Solutions for Gas Utilities User Manual

First, the software verifies and displays the current firmware version and encoder type. A progress bar displays.
OTE:N If necessary, you can click the Cancel button to stop the firmware update and start again later.
Figure 21: RF update progress
Next, the firmware update is validated.
Figure 22: Validating RF update
Finally, a message displays with the new firmware version to confirm the update is complete as shown in the example
below (Figure 23).
OTE:N The software application determines the new firmware version for the update based on the endpoint and
encoder type.
Figure 23: RF firmware update complete
5. To perform another single endpoint RF update, repeat steps 3 and 4.
UPDATING ENDPOINT FIRMWARE
Page 22 April 2014ORION® SE/ME Firmware Updater