Hardware Solutions for Gas Utilities Owner manual

Installation Data
3. Place the four (4) 10 X 24 X 1" screws through the endpoint holes and into the gas meter.
• Tighten the screws to about 15 inch-pounds.
• Test the 2 FT³ or 1 FT³ dial. It should wiggle just a little.
Place the Lens Over the Endpoint and Index
1. Verify the lens gasket is set properly.
2. Place the lens on the gas meter with the endpoint IR Port in the upper left hand corner.
3. Secure the lens with the four (4) 8 X ½" screws. Tighten the screws to about 15 inch-pounds.
Lens Gasket
Endpoint IR Port
(4-11)
Page 13