Hardware Solutions for Gas Utilities Owner manual

Installation Data
Place The Index Onto The Endpoint
Use care when handling the endpoint and index to insure the endpoint drive pawls and the mating index drive gear are not
subjected to any physical abuse. Abuse may cause the spindles to become bent, misaligned or otherwise inoperative.
When attaching an index to an ORION endpoint, make certain the index mounts securely to the endpoint.
The front and rear drive gears must mate without causing any binding or potential for disengagement.
1. Place the index on the endpoint front. Be certain that the endpoint gear and index gears mesh.
2. Screw the index in place with the two (2) #6 X ¾" screws.
3. Test the drive gear connection by turning the 2 FT³ or 1 FT³ dial on the index several times. If dragging or friction is
felt, reposition the index to eliminate the drag. The dial should turn smoothly.
11-Tooth Endpoint
Gear
Index Gear
24-Tooth Endpoint
Gear
Index Gear
(4-11)
Page 11