Hardware Solutions for Gas Utilities
Table Of Contents
- Introduction
- User Guide
- Software Security Modes
- Program Startup and Exit
- Copyright Screen
- Main Menu
- Reading a Route
- Bookmark an Account
- Changing Read Mode
- Work Items
- Requesting Extended Status Manually
- Requesting Firmware Version Manually
- Requesting Historical Interval Data Manually
- Read Menu
- Comments
- Read Direction
- View High/Low
- Manual Read
- Select Route
- Reader Codes
- Trouble Codes
- Text Messages
- Utilities
- Customizations
- Route Info
- Program & Quick Read
- Part II: HandHeld Operation
- Trimble Ranger 3 Handheld Overview
- Factory Reset/Clean Boot
- Using the Handheld Keypad
- Hot Keys, Quick Keys, Read Keys
- Configuration Options
- APPENDIX
- Glossary
- Status Codes
- Valid COM Ports
- Gas Meter Drive Rotation
- Route Memory Stick
- Unloading a Route
- Using VersaProbe with Bluetooth
- Troubleshooting
- Technical Support
Power:
• Tap if you want to select "Maintain Bluetooth
connections when device is turned off."
• Tap if you want to select "Allow Bluetooth activity to
turn the device on." When this check box is selected,
another Bluetooth device can send data and your
unit will turn on and reply if necessary.
MPORTANTI
Leaving wireless options on reduces battery life. It is
recommended that your handheld be configured to
automatically turn off when not in use. Otherwise, another
Bluetooth device could turn on your handheld, transfer
data, and if it does not turn off again, drain the battery.
OTE:N To set up a VersaProbe Bluetooth connection, see "Using VersaProbe with Bluetooth" onpage88.
Receiving Beams
If you want to allow the unit to receive incoming beams, go to Windows Start> Settings> Connections> Beam and check
the box for "Receive all incoming beams."
TRIMBLE RANGER 3 HANDHELD OVERVIEW
Page 71 April 2014 ORION® Field Application for Trimble® Ranger 3