User guide

Programming Manual
Page 15 March 2014
Buttons
MENU – Switches between normal running and programming modes.
UP Arrow (▲) – In programming mode scrolls forward through the parameter choices and increments
numeric variables.
RIGHT Arrow (►) – In programming mode scrolls backward through the parameter choices and moves the active
digit to the right.
ENTER – Used to save programming information, advance to the next programming parameter, and in the
reset process.
TOTAL FLOW RESET – This touch sensor button allows the total to be reset without opening up the case. This button
pertains to the explosion proof version only.
OTE:N The “through the glass” touch sensor button is currently under development in the explosion proof version
of the B3000.
Special Functions
MENU + ENTER – Simultaneously press and hold to reset the current totalizer.
MENU - Press and hold menu for three seconds to enter extended programming mode.
UP Arrow (▲) + Right Arrow (►) – Simultaneously press and hold to show the firmware version number, then the
grand total.
UP Arrow (▲) – In run mode increases display contrast.
RIGHT Arrow (►) – In run mode decreases display contrast.
Modes
RUN – Normal operating mode.
PROGRAM – Used to program variables into the display.
EXTENDED PROGRAM – Used to program advanced variables into the display.
TEST – Used as a diagnostic tool to show input frequency and totalizer counts.
If your monitor was ordered with a Blancett flow meter, the two components ship from the factory configured as a set. If the
monitor is a replacement, the turbine’s K factor changed, or the monitor is used with some other pulse generating device;
programming is necessary.