Instruction Manual

INSTALLATION INSTRUCTIONS, DOUBLE SUPPORT
1. Follow steps 1 through 7 in “Installation Instructions, Single Support” on page 5. At 180° from and on the same plane
as the previously drilled hole, grind the surface of the pipe to provide a clean area for welding. Drill a hole and deburr,
especially on the inside of the pipe. Size the hole used for the double support according to Table 3.
2. Weld the double support weld-o-let, making sure that it is centered with the drilled hole (1/16" weld gap recommended).
Model / Sensor Weld Connector Drill Bit
AS (7/8") 1/2" 1/2"
AS1 (1-1/4") 1" 7/8"
Table 3: Double support drill bit size
3. Install the AS Ellipse sensor through the two holes. Make sure that the double support pin passes through the guide ring.
See Figure 5.
Ellipse Sensor
Double Support Pin
Guide Ring
Figure 6: Double support pin
4. While holding the AS Ellipse in its fully inserted position, align the sensor head with the direction of ow as in step 9,
“Installation Instructions, Single Support” on page 5.
5. Check that the AS Ellipse is in the correct orientation and spans the inside of the pipe. Tighten the compression nut
manually, then use a wrench to tighten it another 1-1/4 turns.
6. Install the plug into the end of the double support weld-o-let. Tighten the plug to prevent leakage. Ensure that there is no
leakage in the system.
7. Follow steps 11 through 15 in “Installation Instructions, Single Support” on page 5.
TYPICAL INSTALLATION WITH DIFFERENTIAL PRESSURE TRANSMITTER
Horizontal Pipes
Vertical Pipes
Ellipse
Sensor
Cross Tees
Pipe
Fill here
with water
1/2" Tubing
3- or 5-Valve
Manifold
DP Transmitter
Figure 7: Installation with differential pressure transmitter
Ellipse® Pitot Tube Meter, AS Annular Threaded Steam Meter
Page 6 April 2014