User Manual

4050 Multi-Input Linear Flow Computer
13
10. PROGRAMMING HELPER
Primary
(Basic settings)
Secondary Program Mode
Enter by pressing ALT &
Serial #
Computed Data
Raw Data Settings
Viscosity Frequency 1, 2 &3 Set-up Auto (Hz Trip points)
Specific Gravity Roshkoe Cards Fitted
(what cards are installed)
Volume Rate 1, 2 & 3 Strouhal Set-up Comms
(Port settings)
Mass 1, 2 & 3 K factor 1, 2 & 3 Edit Curve
(K Factor Programming)
Total Volume A1 Temperature =
ma
Channel set-up 1, 2, 3
Temperature Date Clear Totals
Manifold(on/off) Sort Curve
Volume(on/ off) Set Viscosity
(programming fluid data)
Set specific Gravity
(programming fluid data)
Set Temperature
(setting C or F by ranging ma
output)
Set-up Inputs
(system changes not
recommended)
Sort Vis/Sg/Temp