Owner manual
Turbine Flow Meter, 1100 Series
SPECIFICATIONS
Materials of Construction
Body 316 Stainless Steel
Rotor CD4MCU Stainless Steel
Rotor Support 316 Stainless Steel
Rotor Shaft and
Bearing
Tungsten Carbide
Operating Parameters
Temperature
–150…350° F (–101…177° C).
The meter should not be subjected to temperatures above 350° F (177° C), or below –150° F (–101° C) or the
freezing point of the metered liquid.
Pressure
Maximum pressure ratings as follows:
5000 psi for all NPT meters up to 2 in.
3000 psi for 3 in. and 4 in. Grayloc meters.
800 psi for 3…10 in. grooved end meters.
Accuracy
±1% of reading for 7/8 in. and larger meters.
±1% of reading over the upper 70% of the measuring range for 3/8 in., 1/2 in., and 3/4 in. meters.
Repeatability ±0.1%.
Calibration Water (NIST traceable calibration).
Approvals
“Single Seal”: ANSI/ISA 12.27.01-2003; MWP 5,000 PSI (34.5 MPa), 350° F.
I.S. Entity Parameters with Badger Meter B111109 standard magnetic pickup installed:
Vmax = 10V, Imax = 7mA, Ci = 0µF, Li = 0.9H
End Connections NPT, BSP, Victaulic, Flange, and Hose Barbed.
*Contact the factory for ordering options.
OTE:N Consult factory for pressure ratings for flanged meters.
INSTALLATION
PRESSURE IN EXCESS OF ALLOWABLE RATING MAY CAUSE THE HOUSING TO BURST AND CAUSE SERIOUS
PERSONAL INJURY.
AVERTISSEMENT
LA PRESSION AU-DESSUS DE L’ESTIMATION PERMISE PEUT FAIRE ÉCLATER ET CAUSER LE LOGEMENT LE DOMMAGE
CORPOREL SÉRIEUX.
1. Check the internals of the ow meter for any foreign material. Make sure the turbine rotor spins freely prior to installation.
Also, check uid lines and remove any debris found.
2. Install the ow meter with the ow arrow, etched on the exterior of the meter body, pointing in the direction of uid ow.
Though the meter is designed to function in any position, where possible, install it horizontally with the conduit adapter
facing upward.
3. Thread a magnetic pickup (Badger Meter model B111109 or equivalent) into the conduit adapter completely nger tight
without forcing. Secure with a lock nut if supplied.
4. Install conduit or other ttings suitable for the installation area onto the conduit adapter hub on the ow meter.
Page 4 July 2014