Specifications
Fan Coil Thermostat Controller
Specification and Installation Instructions
www.neptronic.com Page | 10
Humidity Settings
44. “inside humidity sensor offset”
Offset:
Range:
Increment:
± 5%
10 to 90%
0.1%RH
Compare the displayed humidity percentage reading with a known value from a humidistat. This is useful for humidistats
installed in areas where the humidity read is slightly different than the rooms's actual humidity. For example, a humidistat
placed right under the air diffuser. The humidify symbol is also displayed.
45. “humidity control ramp”
Default:
Range:
Increment:
5.0% RH
3 to 10% RH
0.5% RH
Select the desired span for the humidity ramp. The humidify symbol is also displayed.
Anti-Freeze
46. “enable anti freeze protect”
Default:
Range:
No (disabled)
No, Yes
If this option is enabled, heating starts automatically when the temperature drops to 4ºC [39ºF], even if the thermostat is in OFF
mode. Once the temperature reaches 5ºC [41ºF], the heating stops.
BACnet Settings
47. “auto BAUDS RATE”
Default:
Range:
Yes (enabled)
Yes (enable), No (disable)
Enable or disable Auto Baud Rate Detection. If you enable this option, the controller configures its baud rate automatically by
detecting the network speed upon connection to the network (go to Step 48). If you disable this option, you must select the
baud rate manually (go to Step 49).
48. “auto comport BAUDS RATE”
Default:
Range:
No default (information display only)
9600, 19200, 38400, 76800
If you enabled Auto Baud Rate Detection at Step 47, the display shows the baud rate that has been detected. Go to Step 50.
49. “adjust comport bauds rate”
Default:
Range:
9.6 kBps
9.6k, 192.k, 38.4k, 76.8k
If you disabled Auto Baud Rate Detection at Step 47, select the required baud rate manually.
50. “adjust MSTP Mac address”
Default:
Range:
Increment:
1
0 to 254
1
Select the desired MS/TP MAC Address. Each device on the network must have a unique MAC address.
51. “copy config”
Default:
Range:
No
Yes, No
Select Yes to copy the configuration of the existing device to other devices of the same type on the network. If you select No,
go to Step 55.