Specifications

NEW!
NETWORK & WIRELESS
794
NEW!
NETWORK & WIRELESS
13
WHEN YOU NEED IT RIGHT, RIGHT NOW, CALL KELE.
kele.com888-397-5353 USA
WIRING
BAPI WIRELESS RECEIVER AND REPEATER
BA/RCV-EZ AND BA/RPT-EZ
Supply Voltage
RCV-418 17-30 VAC/VDC
RCV-900, RPT 9-15 VDC,
Supply Current
RCV-418 20 mA
RCV-900, RPT 150 mA
Frequency
RCV-418 418 MHz
RCV-900, RPT 900 MHz
Transmission Power 100 mW (repeater)
Range
RCV-418 100 ft
RCV-900, RPT 1000 ft
Receiver Sensitivity
RCV-418, RPT -106 dBm
RCV-900 -110 dBm
Operating Temperature 32° to 140°F (0° to 60°C)
Operating Humidity 5% to 95% RH (non-condensing)
Materials of Construction
ABS Plastic, UL94V-0
Dimensions 2.75"H x 4.8"W x 1.2"D
(7.0 x 12.0 x 3.0 cm)
Weight 0.5 lb (0.2 kg)
Approvals FCC ID#T4F16963N16964 (418 MHz
models only) FCC CFR part 15.247
(900 MHz models)
RoHS Statement Ye s
Warranty 2 years
DESCRIPTION
The BAPI BA/RCV Wireless Receivers detect the radio
signals from sensor transmitters or BA/RPT repeaters and
send the value through a hard-wired RS485 bus to dedicated
output modules. Each receiver can accommodate 127 output
modules, which come in a variety of output types including
thermistor simulation (10K Ω type 2 or 3), 4-20 mA, 0-5 VDC,
0-10 VDC, and solid-state switch. The BA/RCV418 receives
signals directly from sensor transmitters at 418 MHz. The BA/
RCV900 receives signals only from repeaters at 900 MHz.
The BAPI BA/RPT Wireless Repeater detects all 418 MHz
sensor transmitter signals, and re-transmits the signal at
900 MHz to extend useable wireless distance to as far as
1000 feet. These signals are received with a BA/RCV900 for
RS485 communication distribution to the output modules.
FEATURES
• Eliminates point wiring
• FCC license pre-approved
• Receivers accommodate 127 output modules each
• Receiver sensitivity -106 dBm minimum
• Built In error detection
• Repeater transmit power 100 mW
• 1000-foot repeater range (open air)
• Snap-track mounting
SPECIFICATIONS
BA/RCV900-EZ
OPERATION/APPLICATION
The receiver detects the wireless signal from one or more
transmitters, then outputs the value through an RS485
communication line to attached output modules selected
specifically for the input requirements. Module addressing is
made simple by pushing a button on the output module and
transmitter at the same time, thus completing a permanent
wireless address link between transmitter and output module.
BA/EZ RCV 418
Receiver
418 MHz
BA/EZ ROM
Output
1
BA/EZ COM
Output
127
BA/TEMP
Transmitter
BA/EZ RCV 900
Receiver
900 MHz
BA/EZ ROM
Output
1
BA/EZ COM
Output
127
BA/EZ RPT
Repeater
418 MHz
BA/TEMP
Transmitter
* The transmission range from repeater to receiver is 1000 feet.
March 2014