Specifications

NEW!
781
NETWORK & WIRELESS
NETWORK & WIRELESS
13
WE MAKE IT EASY.
kele.com 888-397-5353 USA
Wireless digital transmitters should be installed within 200 to 500 feet of the receiver. RR2552 signal repeaters can be installed as
needed to increase transmission distance between sensors and receivers.
Sensor Location:
To select the proper sensor location, first install and power the receiver. Observing polarity, insert the battery into the sensor to
activate it (for RT2620A, move the voltage selection jumper to battery operation before inserting the battery). The mesh networked
Frontier 2.0 system does not require any additional wireless equipment to determine the proper location of the sensors.
While the sensor is attempting to connect to the receiver, the Data-Link LED will blink rapidly 8-10 times every 10 seconds. Once
a connection has been established the Data-Link LED will blink once to indicate the data transmission has been received
successfully. The Data-Link LED will continue to blink once for every data transmission. The data transmission rate is programmed
into the sensor (normally 1 minute intervals). To manually initiate a data transmission, press the push button switch located by
the negative terminal of the battery.
Installation:
Once the location has been determined, mount the RT2602/RT2620 remote transmitter on a wall using four #8 screws.
Determine if the RT2602/RT2620 remote transmitter will be powered by 24 VAC or by batteries on a permanent basis.
For 24 VAC Operation (RT2620A only):
If the device is to be powered by 24 VAC, move the voltage selection jumper to 24 VAC position and connect 24 V 60 Hz to the
input terminals using 18-20 AWG wire.
For Battery Operation:
If the device is to be powered using the 3.0 volt batteries – remove the voltage selection jumper and reposition it for battery
operation (RT2620A only).
NOTE:
For RT2620A, the device is shipped with the voltage selection jumper installed in the 24 VAC position.
For proper operation it is important to use the correct type of battery. Lithium 3.0V 1400 mAh (Duracell DL123A) batteries.
Installing the battery or applying 24 VAC (RT2620A only) will activate the transmitter again.
Sensor Inputs:
Wire the sensor inputs to the appropriate terminals using 18 AWG wire. Record the sensor location on the wiring label located
inside the cover.
ORDERING INFORMATION
FRONTIER 2.0 WIRELESS DIGITAL INPUT MODULES
RT2602, RT2620
INSTALLATION
MODEL DESCRIPTION
RT2602B Battery powered device with 2 digital inputs
RT2620A Battery powered or 24 VAC powered (field selectable) device with four (4) digital sensor inputs
RT2620B Battery powered only device with (4) digital sensor inputs
CAUTION:
Sensors, Repeaters and receivers should NOT be installed in the following areas:
- Inside metal enclosure or panel
- Inside or immediately next to elevator shaft or elevator banks
- In front of or immediately next to large trees or a large body of water
Transmission distance and performance will be drastically reduced.
CAUTION:
Do not use this product in any safety related applications where human life may be affected.
March 2014