Use and Care Guide

www.BackyardXScapes.com
“Helping Create a New Paradise Everyday”
Stained Effect: Apply a thin coat of approximately 400-500 sq.ft/gal. with brush, roll or applicator pad. This
should minimize sheen development especially on tight, non-absorbing wood grain. Remove excess or
puddled material that has not penetrated after 15 minutes with a paint pad or rags. See special precaution
for rag disposal.
Gloss Varnish Look: Apply a thin coat of approximately 400-500 sq.ft/gal. Allow to dry for 48 hours or until
firm and then apply a second thin coat.
Dry Time: 48-96 hours depending on drying conditions. Drying conditions will vary greatly depending on
applied film thickness and weather conditions. Multi coat applications may be "tacky" for up to 30 days. Full
cure will begin when surface is tack free.
Thinning and Clean-Up: No thinning required. Use mineral spirits for equipment clean up.