Instructions / Assembly

Phase Notes
• Assemble with hardware as shown.
Parts needed:
• (4) M12 - WALL SLAT - A101536
Hardware needed:
• (8) BR - SCREW PFH 8x1-1/8 - H100088
• (8) BQ - SCREW PFH 8x1-1/4 - H100087
Step 1: Attach 'M12' Wall Slats to 'K4'
wall rail using Screws 'BR', as shown.
Note: Due to the changing size of the wood
as a result of moisture content, you may
need to adjust the spacing of your wall slats
1/16" to 1/8" when assembling walls. It would
be best to line up the boards on the wall
before attaching to estimate if a larger or
smaller gap is needed.
Note: Do not overtighten screws, overtightening
may cause the screw to stick through the boards
and may cause sharp points. The head of the
screw should NOT sink into the wood for this
phase, it should be flush.
Note: It is vital that the fort
be level before and after
each phase of assembly.
To prevent board splitting, you
must pre-drill each board with
a 1/8" drill bit, before attaching.
Step 2: Attach 'M12' Wall Slats to 'H2'
floor joist using Screws 'BQ', as shown.
M12
BR
K4
BQ
H2
M12
Fort Assembly
Phase 8