Instructions / Assembly

STEP 2
INSERT (2) 2-1/2" BOLTS, LOCK WASHERS
AND 1-1/2" BARREL NUTS INTO TOP EDGE OF
W71 SWING BEAM SUPPORT, AS SHOWN.
ATTACH E77 ANGLE BRACES TO W71 SWING
BEAM SUPPORT USING 4- 1/2" BOLT, LOCK
WASHERS AND 7/8" BARREL NUT.
ATTACH H79 END SUPPORT TO E77 ANGLE
BRACES USING (2) 2" BOLTS, LOCK
WASHERS AND 7/8" BARREL NUTS. NOW
ATTACH H79 END SUPPORT TO W71 SWING
BEAM SUPPORT USING (2) 2" LAG SCREWS
AND LOCK WASHERS.
ATTACH H80 GROUND BOARD TO E77 ANGLE
BRACES USING (2) 2" BOLTS, LOCK
WASHERS AND 7/8" BARREL NUTS.
BOLT WH
5/16x2
(4)
BOLT WH
5/16x2-1/2
(2)
BOLT WH
5/16x4-1/2
(1)
LAG SCREW
WH 5/16x2
(2)
WASHER
LOCK EXT
8x19
(9)
WASHER
LOCK EXT
12x19
(7)
NUT BARREL
WH 5/16x7/8
(5)
NUT BARREL
WH 5/16x1-1/2
(2)
W71 - SWING BEAM SUPPORT - W102349
2"x3 3/8"x47 3/8" (50x86x1204)
(1)
E77 - ANGLE BRACE - W100991
1 3/8"x3 3/8"x74 3/8" (36x86x1890)
(2)
H79 - END SUPPORT - W100992
1"x3 1/2"x42" (24x86x1072)
(1)
H80 - GROUND BOARD - W100990
1"x3 3/8"x87 3/8" (24x86x2218)
(1)
This Safe-T-Fuse hardware
must be assembled to
improve structural integrity
of swing beam.
W71
E77
E77
H79
H80